10
EN
vaccum cleaner VC 150 E / VC 155 E
Switch on MAX suction level
1. Press the operating button MAX suction level (
3
) once.
3
24
ð
The vacuum power is increased and the LED
display (
24
) lights up.
2. To switch off the MAX suction level (
3
), press the operating
button MAX suction level (
3
) again.
ð
If the MAX suction level (
3
) is switched off, the LED
display (
24
) goes out.
Switching the device off
1. Press the on/off switch (
4
) to switch off the device.
ð
The operating control lamp / battery level indication (
2
)
is no longer illuminated.
ð
The device is switched off.
Shutdown
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Storage chapter.
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
Light smoke or odour is emitted during the first use:
•
This is not a fault. These phenomena disappear after a
brief runtime.
The battery does not charge:
•
Check whether the device is correctly connected to the
charger and whether the charger is correctly connected to
the power supply.
•
Check the power connection.
•
Check the power cable and mains plug for damages.
•
Check the fuse (home).
•
Check the charger for damages. Should the charger be
damaged, stop using it. Contact the Trotec customer
service.
•
Check the charger connection for dirt. Remove any dirt.
•
The battery might be defective. Contact the Trotec
customer service.
The device becomes hot:
•
Keep the venting slots clear to prevent the motor from
overheating.
•
Check the air outlet filters regularly and keep them free
from dirt. Blocked air outlet filters can cause overheating
of the motor.
•
Check the device for blockages, large objects can block
the suction nozzles or the collection container. An
interrupted air flow causes motor overheating. Remove
potential blockages and do not vacuum any large objects.
Info
Wait for at least 10 minutes before switching the
device back on.
