EN
Operating manual – Infrared heating panel TIH 500 S / TIH 700 S
4
Check whether the power cable is intact. If the power cable is
damaged, it must be replaced by the manufacturer, his customer
service or similarly qualified personnel. Make sure that the
electrical properties of the socket correspond to the values
specified in the operating manual or on the nameplate.
Switch-on
1. Plug the device into a sufficiently fused socket.
– The device is switched on and works automatically.
Switch-off
1. Pull the plug from the mains socket.
2. Allow the device to cool down.
The device still does not operate correctly after these
checks?
Bring the device to a specialist company or to Trotec for repairs.
For maintenance or repair work which requires the
housing to be opened, contact the Trotec customer
service.
Activities required before starting maintenance
• Do not touch the mains plug with wet or damp hands.
• Before any work, detach the mains plug!
• Allow the device to cool down for at least 15 min.
Cleaning the outside of the device
Clean the device with a soft, damp and lint-free cloth. Do not use
sprays, solvents or harsh cleaners to dampen the cloth.
In the European Union, electronic equipment must not
be treated as domestic waste, but must be disposed of
professionally in accordance with Directive
2002/96/EC of the European Parliament and of the Council of
27 January 2003 on waste electrical and electronic equipment
(WEEE). At the end of its life, please dispose of this device
according to the valid legal requirements.
Operation
Errors and faults
Fault
Cause
Remedy
The device makes
noises after switch-on
The material expands due
to heating. The insulation
expands as well and
generates the noises.
This is a normal process.
No measures are
required.
The surface of the
device bulges outward
The material expands due
to heating.
This is a normal process.
No measures are
required.
The surface only heats
up slightly
The mains voltage does
not meet the
requirements.
Check the mains voltage.
The ambient temperature
is low.
This is a normal process.
No measures are
required.
Maintenance and repair
Disposal
