EN
6
Operating manual – gas heater fan TGH 10 E / TGH 15 E / TGH 30 E
Transport and storage
Notice
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with a
transport handle.
Before
transporting the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Do not use the gas hose to drag the device.
•
Allow the device to cool down sufficiently.
•
Close the valve at the gas cylinder and disconnect the gas
hose.
•
Transport gas cylinder and device separately.
After
transporting the device, observe the following:
•
Please observe the information for device set-up:
•
Re-connect the gas hose and carry out a leak test (see
chapter Assembly and installation).
Storage
Before
storing the device, proceed as follows:
•
Close the valve at the gas cylinder and disconnect the gas
hose.
•
Allow the device to cool down sufficiently.
When the device is not being used, observe the following
storage conditions:
•
dry
•
under roof
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust, if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
•
Store gas cylinder and device separately.
•
The storage temperature is the same as the range given
for the operating temperature in the technical data.
Assembly and installation
Scope of delivery
•
1 x Device
•
1 x Gas hose, class 2, 6.3 mm, 10 bar, length: 1.5 m
•
1 x Pressure reducer 700 mbar, suitable for gas cylinders
from Germany, Austria, Belgium, the Netherlands and
Poland
•
1 x Transport handle
•
2 x Screw
•
2 x Washer
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Use tools suitable for the intended task.
Mounting the transport handle
Prior to initial start-up, the transport handle must be attached to
the device.
The procedure is identical for the devices
TGH 10 E / TGH 15 E /
TGH 30 E
.
To do so, please proceed as follows:
1. Loosen the two screws and the two washers from the top
of the housing.
Summary of Contents for TGH 10 E
Page 16: ......
