Trotec TES 200, Original Instructions Manual

Page: 8 / 27

8 EN vertical heater TES 200
Assembly and installation
Scope of delivery
TES 200
• 1 x Device
• 1 x DualDecon blowing-out tower
• 3 x flowstop shutters
• 1 x Manual
Assembly
Mounting the blowing-out tower and inserting the
H14 HEPA filter
1. Using a screwdriver, remove the protective caps of
the 4 screws from the top of the device.
2. Remove all 4 screws.
3. Take off the blowing-out tower (1) from the device.
4. If required, insert a HEPA air filter.
5. Place the desired blowing-out tower on the device.
6. Fasten the blowing-out tower by means of the screws.
7. Put the protective caps back on the screws.
1
Start-up
When positioning the device, observe the minimum distance
from walls or other objects as described in the Technical data
chapter.
• Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
• The device may only be used in environments with no
excessive formation of dust.
• Set the device up in an upright and stable position.
• Position the device on even, stable and heat-insensitive
ground in a way to prevent it from tipping over.
• When setting up the device, ensure a sufficient distance
for air inlet and outlet as well as for operation (see
Technical data).
• Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
• Make sure that extension cables are completely unrolled.
• Make sure that no curtains or other objects interfere with
the air flow.
• Make sure that the device cannot come into contact with
moisture or water.
Inserting the air filter
Note
Do not operate the device without an air filter inserted
into the air inlet!
Without the air filter, the inside of the device will be
heavily contaminated. This could reduce the
performance and result in damage to the device.
• Make sure that the air filter is installed before switching
the device on.
Attaching a flowstop shutter
Each of the three flowstop shutters can be attached to one of
the four insides of the tower. This prevents up to three sides of
the tower from discharging air, e.g. if discharged air is not
desired or required on the respective side(s).
Connecting the power cable
• Insert the mains plug into a properly secured mains
socket.