Trotec TDS 30, Operating Manual

Page: 6 / 12

4 Operating Manual – Electrical Fan Heater TDS 30 EN
For maintenance or repair work which requires the
housing to be opened, contact the Trotec customer
service. Devices which have been opened
unlawfully are void of any warranty and warranty
claims.
Activities required before starting maintenance
• Do not touch the mains plug with wet or damp hands.
• Before any work, detach the mains plug!
Cleaning the housing
Clean the device with a soft, damp and lint-free cloth. Ensure that
no moisture enters the housing. Do not use any sprays, solvents,
alcohol-based cleaning agents or abrasive cleaners, but only
clean water to moisten the cloth.
Errors and faults
Fault Cause Remedy
The device is switched
on, the fan is operating,
the heating is not. The heating resistor has
blown. Have it replaced.
Room thermostat is
defective. Have it replaced.
The device does not
switch on. Motor is defective. Have it replaced.
Mains voltage is
interrupted. Unplug and check mains
connection.
The air current is
reduced. Air inlet is blocked. Clean air inlet and
remove obstruction.
Fan motor is defective. Have it replaced.
Maintenance and repair