Pre-Installation Instructions
8014 Trotec Speedy 500
Computer and Software Requirements
13/12/2011
Trotec Produktions- und Vertriebs GmbH
_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support
11 / 15
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto:
2 Computer and Software Requirements
Remember that the laser system is an output device just like a printer. With a higher specified
computer you can create graphics and manipulate your software faster and process data faster to
the laser, increasing your productivity.
Also in order to install and configure software during installation, full administrative rights access is
required.
2.1 Minimum Computer Configuration for JobControl
•
Windows 7® 32/64-bit or
Windows Vista® 32/64-bit (with Service Pack 1 or later) or
Windows® XP 32/64-bit (with Service Pack 2 or later)
•
512 MB of RAM
•
400 MB of hard disk space
•
Pentium® 1 GHz processor or AMD Athlon™ XP
•
1024 x 768 or better monitor resolution
•
24-bit color depth graphics card
•
1 free USB interface
•
CD
drive
•
Mouse
2.2 Minimum Computer Configuration for TroCAM
•
Windows® XP Service Pack 3 or
Windows 7® 32/64-bit
•
2 GB RAM for 32 bit / 6 GB RAM for 64 bit
•
120 GB hard disk space
•
Intel i5 / i7 Processor
•
DVD
drive
•
Serial Port (preferred) or
USB port for connection between PC and Laser
2.3 Minimum Computer Configuration for I-Cut
•
Windows 7® 32/64-bit or
Windows Vista® 32-bit (with Service Pack 1 or later) or
Windows® XP 32-bit (with Service Pack 2 or later)
•
1 GB RAM
•
500 MB hard disk space
•
2 GHz Processor
•
PCI-Express-Slot X1 (22 + 14 Pins)
•
USB port for I-Cut Dongle
•
Serial port (preferred) or
USB port for connection between PC and Laser
