6
EN
LED work lamp PWLS 05-10 / PWLS 06-10
PWLS 06-10
Parameter
Value
Surface LED
Power input
10 W
Luminous flux
800 lm
Burn time
high light-intensity
= 4-5 h
low light-intensity
= 8-9 h
Colour temperature 6000 K
Dimensions (length x width x height)
40 x 160 x 125 mm
Weight (packaging excluded)
434 g
Length USB cable
0.8 m
Nominal voltage USB connection (output) 5 V
Nominal current consumption
USB connection (output)
1 A
Battery type
Li-ion
Battery voltage
3.7 V
Battery capacity
4400 mAh
Charging time
6-7 h
Permitted ambient temperature (when
stored)
-30 °C-75 °C
Operating temperature
-20 °C-55 °C
Type of protection
IP 44
Protection class
III
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with a
transport handle.
Before
transporting the device, observe the following:
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Switch the device off.
•
Allow the device to cool down.
•
Remove the batteries from the device
PWLS 05-10
.
•
Disconnect the USB charging cable from the device
PWLS 06-10
.
The supplied batteries are subject to the requirements of
dangerous goods legislation.
Observe the following when transporting or shipping batteries:
•
The user may transport the batteries by road without any
additional requirements.
•
If transport is carried out by third parties (e.g. air transport
or forwarding company), special requirements as to
packaging and labelling must be observed. This includes
consulting a dangerous goods specialist when preparing
the package.
– Only ship batteries if their housing is undamaged.
– Mask open terminals with tape and pack the battery in
a way that it cannot move inside the packaging.
– Please also observe any other national regulations.
Storage
Before
storing the device, proceed as follows:
•
Switch the device off.
•
Pull the USB charging cable (13) out of the device
PWLS
06-10
.
•
Allow the device to cool down.
•
Remove the batteries from the device
PWLS 05-10
.
•
Clean the device as described in the Maintenance chapter.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
Ambient temperature below 75 °C
•
protected from dust and direct sunlight
Start-up
Unpacking the device
•
Take the device and the accessories out of the packaging.
Warning of electrical voltage
Electric shock from insufficient insulation.
Check the device for damages and proper functioning
before each use.
If you notice damages, no longer use the device.
Do not use the device when the device or your hands
are damp or wet!
•
Check the contents for completeness and look for
damages.
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
•
Dispose of the packaging material according to the
national regulations.
Inserting batteries for PWLS 05-10
You need 4 AA 1.5 V batteries for the device
PWLS 05-10
.
Insert the batteries into the device prior to use. Please proceed
as follows:
