EN
12
cordless screwdriver with bit magazine PSCS 11-3,6V
Shutdown
1. Set the switch for clockwise/counter-clockwise rotation (5)
to centre position (lock).
2. If required, allow the device to cool down.
3. Remove the tool from the device (see Start-up chapter).
4. Clean the device according to the Maintenance chapter.
5. Store the device according to the Storage chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than those
specified in the operating manual may cause a risk of
injury.
Accessories
Article number
Screw bit set, 32-piece
6,200,001,001
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
Slight smoke or odour are emitted during first use:
•
This is not a fault. These phenomena disappear after a
brief runtime.
The battery does not charge:
•
Check whether the device is correctly connected to the
charger and whether the charger is correctly connected to
the power supply.
•
Check the power connection.
•
Check the power cable and mains plug for damages.
•
Check the fuse (home).
•
Check the charger for damages. Should the charger be
damaged, stop using it. Contact the Trotec customer
service.
•
Check the charger connection for dirt. Remove any dirt.
•
The battery might be defective. Contact the Trotec
customer service.
The device does not start:
•
The battery power might be too low. Recharge the battery.
•
Check the position of the clockwise / counter-clockwise
rotation switch. The switch must be pressed in all the way.
If the clockwise / counter-clockwise rotation switch is in
centre position (lock), the on / off switch is blocked.
•
Check whether the charger is connected. If the charger is
connected, the device will not start.
Info
Wait for at least 10 minutes before switching the
device back on.
The on/off switch cannot be pressed:
•
Check whether the clockwise/counter-clockwise rotation
switch is in centre position (lock). Set the desired rotational
direction to unlock the tool.
Note
Wait for at least 3 minutes after maintenance and
repair work. Only then switch the device back on.
Your device still does not operate correctly after these
checks?
Please contact the customer service. If necessary, bring the
device to an authorized specialist electrical company or to
Trotec for repair.
Summary of Contents for PSCS 11-3,6V
Page 16: ......
