SpeedMarker 300 /
ProMarker 300
Ausgabe 1.0
Technische Änderungen vorbehalten.
TROTEC Produktions- u. Vertriebs GmbH
Linzer Straße 156, A
– 4600 Wels
Seite
29
von 42
8
Installation
Installation Location
The installation location must:
have a non-fluctuating power supply
be vibration free
have sufficient air supply for the laser module and PC
The laser module and the PC should be located next to or directly above one another if possible in order
for the modules to be connected to one another with the cables provided..
Electrical Installation
All connectors are clearly identified in order to facilitate the electrical installation. A connector marked X43 belongs
to the socket with the same denotation.
The connector denotations are also coded. The last digit of the connector denotation identifies the respective hard-
ware components. Therefore:
X …1 Laser module
X …2 Marking head
X …3 PC
8.2.1
Overview - PC Interface (Reverse Side)
Connectors X93 and X103 are joined directly to one another via a short cable.
Connector X53 is joined to X51 on the laser module using the cable supplied.
X53
X93
X103
X83
TLC2
card
Combination
board slot
