8
EN
850W pendulum action jigsaw PJSS 13-230V
Technical data
Parameter
Value
Model
PJSS 13-230V
Power supply
230 V / 50 Hz
Power consumption
0.85 kW
Idle speed
0 – 3,000 rpm
Cutting angle
0° / 15° / 30° / 45°
Max. cutting depth (mm)
Wood
Metal
Plastic
80
8
10
Cable length
3 m
Protection class
II (double insulation) /
Weight
2 kg
Vibration information according to EN 62841
Total vibration emission value:
Sawing chipboards a
h,B
Uncertainty K
9.5 m/s²
1.5 m/s²
Sawing sheet metal a
h,B
Uncertainty K
11.2 m/s²
1.5 m/s²
Sound values according to EN 62841
Sound pressure level L
pA
88 dB(A)
Sound power L
WA
99 dB(A)
Uncertainty K
3 dB
Wear hearing protection.
Excessive noise can lead to hearing loss.
Information on noise and vibration:
•
The specified total vibration
and noise emission values
were measured by means of a test procedure standardized
in EN 62841 and can be consulted for the comparison of
one power tool with another.
•
The specified total vibration
and noise emission values
can also be used for preliminary load assessment.
Caution
Vibration emissions can cause a health hazard if the
device is used for an extended period of time or if it is
not properly handled and maintained.
•
The actual vibration
and noise emission
may differ from
the stated values during operation of the power tool. This
depends on how the power tool is used and especially on
the type of workpiece being processed. Try to keep the
vibration load to a minimum. Exemplary measures for
reducing the vibration load include wearing gloves during
operation of the tool and the limitation of working hours.
All parts of an operating cycle must be considered for this
(e.g. times at which the power tool is switched off and
times when it is switched on but runs without load).
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down.
•
Remove the tool from the tool holder.
•
If attached, disconnect the dust extraction system from the
device.
Storage
Before
storing the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down.
•
Remove the tool from the tool holder.
•
If attached, disconnect the dust extraction system from the
device.
•
Clean the device as described in the Maintenance chapter.
When the device is not being used, observe the following
storage conditions:
•
Dry and protected from frost and heat
•
Ambient temperature below 45 °C
•
protected from dust and direct sunlight