7
EN
compressor PCPS 10-1100
Technical data
Parameter
Value
Model
PCPS 10-1100
Max. pressure
8 bar (116 psi)
Max. air flow rate
10.8 m
3
/h
Suction capacity
approx. 180 l/min
Idle speed
3550 rpm
Weight
6.0 kg
Nominal voltage
~ 230 V / 50 Hz
Power consumption
1100 W
Nominal current
4.5 A
Operating mode
S3 15 % 10 min*
Cable length
5 m
Hose length
3 m
Hose diameter
12 mm
Protection class
II /
Sound values according to
ISO 2151
Sound pressure level L
pA
94.1 dB(A)
Uncertainty K
pA
3 dB(A)
Sound power level L
WA
95.1 dB(A)
Uncertainty K
WA
1.94 dB(A)
*Operating mode S3 15 % 10 min: This compressor is
designed for intermittent operation. This means that over a
period of 10 min the maximum switch-on time may be 15 %
(1.5 min).
Wear hearing protection.
Excessive noise can lead to hearing loss.
Information on noise and vibration:
•
The specified noise emission values were measured by
means of a test procedure standardized in ISO 2151 and
can be consulted for the comparison of one power tool
with another.
•
The specified noise emission values can also be used for
preliminary load assessment.
•
The actual noise emission may differ from the stated
values during operation of the power tool. This depends on
how the power tool is used and especially on the type of
workpiece being processed.
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down.
Storage
Before
storing the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down.
•
Clean the device as described in the Maintenance chapter.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
ambient temperature below 40 °C
•
the compressed-air hoses must not be kinked
•
protected from dust and direct sunlight
Start-up
Unpacking the device
•
Take the device and the accessories out of the packaging.
Warning of electrical voltage
Electric shock from insufficient insulation.
Check the device for damages and proper functioning
before each use.
If you notice damages, no longer use the device.
Do not use the device when the device or your hands
are damp or wet!
•
Check the contents for completeness and look for
damages.
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
•
Dispose of the packaging material according to the
national regulations.
