13
EN
Operating manual – angle grinder PAGS 10-230
9. Slowly turn the clamping nut (15) to the locking point until
the lock is fixed. Press and hold the spindle lock (1).
10. Retighten the clamping nut (15) by means of the pin-type
face wrench (16). Then let go of the spindle lock (1).
Pay attention not to damage the cutting disc.
15
16
1
11. Check the cutting disc (14) for tight fit.
12. Check whether the cutting disc can rotate freely. Make sure
that the disc does not touch the guard or any other parts.
13. Carry out a test run of approx. 1 minute without load prior to
every disc change and every start-up in order to check the
cutting disc for correct fit.
Caution
If the disc is out-of-round, rotates unevenly, vibrates,
oscillates, or if unusual noises or sparks are generated,
the cutting disc must be exchanged immediately.
Otherwise, there is a risk of injury.
Connecting the power cable
1. Insert the mains plug into a properly secured mains socket.
Operation
Tips and notes on handling the angle grinder
General information:
•
Carry out a test run of approx. 1 minute without load prior
to every disc change and every start-up in order to check
the cutting disc for correct fit.
•
Only use tools which are approved for the device used.
•
Before every application, make sure that you have selected
the correct tool for the intended use.
•
Check the tool in the tool holder for proper fit before every
application. The tool must be firmly locked in place in the
designated holding fixtures on the tool holder.
•
Check whether the cutting disc can rotate freely. Make
sure that the disc does not touch the guard or other parts.
•
Only use discs with a speed imprinted that is at least as
high as the speed indicated on the device's nameplate.
•
Clamp the workpiece unless it is firmly and safely
positioned by its own weight.
•
Do not overload the device so that it comes to a standstill.
•
After operation at high load, let the device run at idle for
several minutes to allow the tool to cool down.
•
Do not touch the discs until they have cooled down.
•
Keep the venting slots clear to prevent the motor from
overheating.
Cutting:
•
Only use intact, flawless cutting discs. Bent, blunt or
otherwise damaged cutting discs could break.
•
Never use the cutting disc for roughing!
•
Only advance moderately during operation and make sure
that the cutting disc does not get jammed.
•
Do not slow down the decelerating cutting disc by pressing
against the side of the disc.
•
Always move the cutting disc through the workpiece in
reverse rotation.
