6
EN
electric heater TEH 20 T / TEH 30 T
Assembly and installation
Scope of delivery
•
1 x device
•
1 x manual
Start-up
Info
Odours might arise upon initial start-up or after a
longer period of non-use.
When positioning the device, observe the minimum distance
from walls or other objects as described in the chapter
Technical annex.
A
B
C
C
D
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
The device may only be used in environments with no
excessive formation of dust.
•
Set the device up in an upright and stable position.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
Make sure that no curtains or other objects interfere with
the air flow.
•
Make sure that the device cannot come into contact with
moisture or water.
Connecting the power cable
•
Insert the mains plug into a properly fused mains socket.
•
Make sure that the power cable is guided along the back
of the device. Never guide the power cable along the front
of the device!
Operation
•
Avoid open doors and windows.
•
Stackable: up to 3 devices may be stacked on top of one
another.
Control panel
8
7
6
No.
Designation
Meaning
6
Rotary switch
temperature
For setting the desired room
temperature
7
Operating control
lamp
Illuminated during the heating
process
8
On/off switch
Switching the device on/off
Is illuminated when the device is
switched on
Switching the device on
Once you have completely installed the device as described in
the chapter Assembly and start-up, you can switch it on.
Info
The device will not be switched on until the room
temperature falls below the temperature set at the
room thermostat. This holds true for the cold setting as
well (ventilation only).
1. Set the on/off switch (8) to
I
to switch the device on.
ð
The on/off switch is illuminated in green and the fan
switches on.