EN
7
radiant heater IRS 2110
Assembly and start-up
Scope of delivery
•
1 x Device
•
1 x Foot
•
4 x Screw
•
3 x Telescopic rod
•
2 x Washer
•
1 x Remote control
•
1 x manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Warning of electrical voltage
Risk of injury due to incorrect assembly!
Local or national regulations may apply for installation.
We recommend to have the installation carried out by a
qualified electrician.
Warning
Risk of fire due to improper installation!
There is a risk of fire if the required minimum
distances are not observed.
Observe the “Installation” section in the “Assembly and
start-up” chapter and the technical data in the
“Technical annex” chapter.
1. Set the foot (
5
) up in an upright position.
2. Connect the three component parts of the telescopic
rod (
4
) with the foot (
5
) as shown by tightening them.
5
4
3. Connect the plug of the power cable to the socket of the
radiant heater.
ð
Fix the plug of the power cable.
