EN
9
radiant heater IR 2001
Operation
Switching the device on
Once you have completely installed the device as described in
the chapter Assembly and start-up, you can switch it on.
Warning of hot surface
The grille (2) heats up during operation and can still be
hot after switch-off.
Do not touch the grille (2) during operation, wait until it
has cooled down after switch-off.
1. Set the mains switch (
3
) to position
ON
.
ð
The mains switch (
3
) is illuminated.
ð
The heater will be switched on and starts heating.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Switch the device off by setting the mains switch (
3
) to
position
OFF
. The operating light flashes red.
•
Allow the device to cool down completely.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Transport and storage
chapter.
Errors and faults
Warning of electrical voltage
Tasks which require the device to be opened must
only be carried out by authorised specialist
companies or by Trotec.
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
The device does not start:
•
Check the power connection.
•
Check the power cable and mains plug for damage. If you
notice damages, do not try to take the device back into
operation.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
•
Check the on-site fusing.
•
Wait for 10 minutes before restarting the device. If the
device is not starting, have the electrics checked by a
specialist company or by Trotec.
The device does not emit heat:
•
The heating element may be defective. If the heating
element is defective, have it replaced by a specialist
electrical company.
•
Check the mains switch (
3
). If the mains switch is set to
the
OFF
position, the device is switched off. Switch the
device on.
RCD or another fuse trips:
•
Check the fuse. Switch off any other devices to reduce the
load on the line.
•
Contact a specialist electrical company.
The device slightly vibrates during switch-on and then
stops vibrating:
•
Slight vibrations during switch-on are a normal process.
No measures are required.
Note
Wait for at least 3 minutes after maintenance and
repair work. Only then switch the device back on.
The device still does not operate correctly after these
checks:
Please contact the customer service. If necessary, bring the
device to an authorised specialist electrical company or to
Trotec for repair.
