EN
9
oil heater IDS 30 F
Assembly and start-up
Scope of delivery
•
1 x Device
•
1 x Filler neck retainer
•
1 x Frame attachment
•
1 x Rain cap
•
1 x Exhaust duct extension
•
1 x Flue pipe
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Mounting the transport frame
Upon delivery the transport frame is already partially
preassembled. The protective bars at the front and rear are still
to be mounted.
1. Attach the first protective bar at the front of the device.
2. Tighten the screws on both sides.
3. Affix the rear protective bar using 2 screws on each side.
ON
ON
ON
ON
4. Check the protective bars for tight fit.
1
2
13
Flue gas evacuation
•
Prior to planning the flue gas system, gather information
about the national legislation and contact a responsible
specialist (cf. DIN 18160 in Germany).
•
Ensure an unimpeded and sufficient combustion air supply
(e.g. by means of ventilation openings in doors, ceilings,
windows, walls or via interconnected airways).
•
Have the exhaust emission of the burner checked at
regular intervals.
