EN
7
oil heater IDS 30 F
Schematic inside view
16
14
17
15
18 19
20
No.
Designation
14
Combustion chamber
15
Burner
16
Nozzle
17
Magnet valve
18
Motor
19
Fan
20
Pump
Control panel
22
23
24
25
21
No.
Designation
21
Selector switch:
•
l
=
ON
(activate manual operation)
•
0
= switch the device off
•
l
=
ON
(activate automatic operation)
22
Thermostat socket
23
Lamp
24
Power cable
25
Reset button
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Allow the device to cool down sufficiently.
•
Loosen the quick couplings at the tank connection.
•
When using the optional jerrycan adapter:
– Remove the nozzle for refuelling from the jerrycan.
– Insert the filler neck in the retainer.
– Close the fastener.
ON
ON
Before transporting the device, disassemble the flue pipe and
put it into the designated holding fixture.
Proceed as follows to disassemble the flue pipe:
1. Remove the rain cap (1) from the flue pipe.
2. Remove the flue pipe (2) from the flue pipe connection.
3. Put the flue pipe into the holding fixture at the device.
4. Attach the rain cap (1) to the flue pipe connection (13).
