6
EN
condenser dryer DH 105 S / DH 115 S
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with wheels.
Always utilize the help of another person to transport the device.
Do not try to transport the device without the help of another
person. To lift the device, use a forklift or an elevating truck as
appropriate.
Before
transporting the device, observe the following:
•
Wait until the condensate pump stops pumping
condensate.
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
•
Remove the condensation drain hose.
•
Only wheel the device on a level and smooth surface.
After
transporting the device, observe the following:
•
Set up the device in an upright position after transport.
•
After having transported the device in horizontal position,
leave the device to rest for 12 to 24 hours, so the
refrigerant can accumulate within the compressor. Wait
12 to 24 hours before switching the device back on! Acting
contrary might lead to compressor damage and a
malfunctioning device. Any warranty claims will be voided
in this case.
Storage
Before
storing the device, proceed as follows:
•
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust, if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and installation
Scope of delivery
•
1 x Device
•
1 x Condensation drain hose
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Start-up
When positioning the device, observe the minimum distance
from walls or other objects as described in the Technical data
chapter.
A
B
C
C
D
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Set the device up in an upright and stable position.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
When positioning the device, keep a sufficient distance to
heat sources.
