7
EN
Operating manual – thermohygrometer BC25
Transport and storage
Notice
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
For transporting the device use a suitable bag to protect it from
external influences.
Storage
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat.
•
protected from dust and direct sunlight.
•
with a cover to protect it from invasive dust, if necessary.
•
Remove the batteries from the device.
Operation
Inserting / Changing the batteries
Notice
Make sure that the surface of the device is dry and the
device is switched off.
1. Open the battery compartment by unscrewing it with a
suitable object (e.g. a coin).
2. Remove the battery cover.
3. Insert the battery (1 x CR2032 battery) into the battery
compartment with correct polarity.
4. Screw the cover back on the battery compartment.
Switch-on and measurements
Note:
Note that moving from a cold area to a warm area can lead to
condensation forming on the device's circuit board. This
physical and unavoidable effect can falsify the measurement. In
this case, the display shows either no measured values or they
are incorrect. Wait a few minutes until the device has become
adjusted to the changed conditions before carrying out a
measurement.
1. Press the Power button (5).
ð
The display is switched on and the device is ready for
operation.
ð
The
TEMP
indication (20) and the currently measured
temperature value are displayed.
2. Point the device at the area to be measured.
ð
Wait for a moment to achieve a stable measured value.
