EN
9
radiant heater IR 2200
Connecting the power cable
•
Insert the mains plug into a properly fused mains socket.
•
Make sure that the power cable is guided along the back
of the device. Never guide the power cable along the front
of the device!
•
Make sure that the mains cable does not touch any hot
parts of the housing.
Operation
Operating elements
10
9
11
9
No.
Designation
9
On/off switch
10
Operating control lamp
11
Remote control receiver
Switching the device on
Once you have completely attached the device as described in
the chapter Assembly and start-up, you can switch it on.
1. Set the mains switch (
6
) to position
I
.
ð
The bottom operating control lamp (
10
) is illuminated.
ð
The device is now in standby mode.
2. Press the on/off switch (
9
) on the device or remote control
for several times to select the desired heating level.
ð
The top and bottom operating control lamps (
10
) are
illuminated.
ð
Depending on the selected heating level, one or both
heating elements will be switched on.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Set the mains switch (
6
) to position
0
.
•
Allow the device to cool down completely.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Transport and storage
chapter.
