EN
7
air cooler PAE 19 H
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with wheels.
To make the device easier to transport, it is fitted with a carry
handle.
Before
transporting the device, observe the following:
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Empty the water tank.
•
Do not use the power cable to drag the device.
•
Only wheel the device on a level and smooth surface.
After
transporting the device, proceed as follows:
•
Set up the device in an upright position after transport.
Storage
Before
storing the device, proceed as follows:
•
Empty and clean the water tank prior to storage (see
chapter Maintenance).
•
Allow the evaporation filter to dry prior to storage.
Otherwise the device may distribute a musty smell after
restart.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down sufficiently.
When the device is not being used, observe the following
storage conditions:
•
Store the device in a dry location and protected from frost
and heat.
•
Store the device in an upright position where it is protected
from dust and direct sunlight.
•
If required, use a cover to protect the device from invasive
dust.
•
Remove batteries from the remote control.
The power cable can be reeled around the clips on the water
tank for storage. To do so, please proceed as follows:
1. Turn the clips on the water tank into a horizontal position.
2. Wrap the power cable completely around the two clips.
Assembly and start-up
Scope of delivery
•
1 x Device
•
1 x Evaporation filter
•
1 x Air filter
•
1 x Ice pack
•
1 x Remote control
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Start-up
When positioning the device, observe the minimum distance
from walls or other objects as described in the chapter
Technical annex.
A
B
C
C
D
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Place the device in an upright and tilt-proof position onto a
stable, load-bearing, even substrate that is insensitive to
heat.
