EN
7
radiant heater IR 2010 SC
Assembly and start-up
Scope of delivery
•
1 x device
•
1 x wire rope with carabiner hook
•
1 x Remote control
•
1 x manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Warning of electrical voltage
Risk of injury due to incorrect assembly!
Local or national regulations may apply for installation.
We recommend to have the installation carried out by a
qualified electrician.
Warning
Risk of fire due to improper installation!
There is a risk of fire if the required minimum
distances are not observed.
Observe the “Installation” section in the “Assembly and
start-up” chapter and the technical data in the
“Technical annex” chapter.
Warning
The device must not be placed directly below a socket,
as the electrical cables may be hit when the device is
being mounted. This may cause an electric shock.
ü
A suitable ceiling holder is preassembled.
ü
Make sure that the on/off switch (
3
) of the device is in
position
0
.
1. Screw the setscrews
4
) of the wire rope (
2
) into the holes
provided (
8
).
2. Fasten the device on the ceiling by hooking the carabiner
hook (
1
) into the ceiling holder. Observe the minimum
distances to the ceiling and floor (see chapter Technical
data).
ð
Check the closure of the carabiner hook (
1
) and close it.
4
8
1
2
Installation
When installing the device, observe the minimum distances
from walls and other objects as described in the Technical data
chapter.
•
Do not install the device directly behind a door.
•
Never install the device in a way that it radiates directly
onto walls or other objects. Observe the minimum
distances from walls or other objects according to the
Technical data chapter.
