Chapter 1
Tropos 7320 Router Installation Guide
28
FIGURE 17
Connecting Streetlight Power
Warning
Connect the outdoor system only to a twist-lock style outdoor lighting control powered by 100-480 VAC
50/60 Hz. Do not connect it to twist-lock style outdoor lighting controls powered by higher voltage.
Connect a streetlight power source
1.
Verify that the service voltage is 100-480 VAC 50/60 Hz.
2.
Verify that power is turned off on the designated circuits.
3.
Remove the photosensor from the streetlight.
4.
Connect the NEMA 3 prong plug from the router to the photosensor connector on the street
light.
Note
Make sure that you include a service loop on both ends when installing the power cord. The service loop at
the street light end should be long enough to allow full 360 degree rotation of the power adapter on the
photosensor socket.
5.
Connect the photosensor to the top of the NEMA 3 prong plug.
6.
Connect the AC plug to the router and tighten hand-tight.
7.
Reenergize the circuit and confirm that power to the router comes on.
AC power from
power adapter
on photosensor
AC power from
power adapter
on photosensor
