1
Fire Pit Riser
Assembly Instructions
Congratulations on the purchase of your Tropitone
®
Fire Pit Riser.
Read through all steps before fastening components together.
WARNING:
Do not try to lift or flip components with only one
person. Components may be heavy and awkward to handle,
and may result in injury to persons or damage to property if
not lifted properly. Safety Glasses must be worn when
drilling holes in frame components.
CAUTION:
When instructed to fully tighten screws, do not
over tighten and strip the threads.
Read through all steps before starting
assembly.
Completely unpack all boxes and thoroughly
check for items that may be individually
wrapped.
Check that all items listed in the Parts List are in
your cartons.
Tools Required
7/16” Open End Crescent
Wrench
Safety Glasses
Round Fire Pit Riser Parts List Square Fire Pit Riser Parts List
(1) Round Fire Pit Riser
Frame
(4) ¼” - 20 x ¾ “ Hex Head
Cap Screws
(4) ½“ Lock Washers
(1) Square Fire Pit Riser Frame
(4) ¼” - 20 x ¾ “ Hex Head Cap
Screws
(4) ½“ Lock Washers
^
2
CAUTION: Before installing the Riser on your Fire Pit, be sure to
remove the propane gas tank or disconnect the natural gas
connection.
Fire Pit Riser Assembly
Prepare a smooth, non-scratch surface (a tarp or pool towels can
be placed on your work surface). Place your Fire Pit on its side on
the prepared work surface.
Remove the glides from the bottom of your Fire Pit. Retain the
glides. They will be used on the Fire Pit Riser.
Install the glides by screwing them in to the bottom of the Fire Pit
Riser. See diagrams below for both the Round Fire Pit Base and
the Square Fire Pit Base.
Round Fire Pit Base
Trim Detail
l
