Evo Pedestal Table Top Attachment
360936B Dining Base
360997B Bar Height Base
Thank you for selecting Tropitone furniture.
Read through all steps before starting assembly.
Locate all items in the Parts List from your cartons.
WARNING!
Do not try to lift or flip furniture components
with only one person. Components may be heavy and
awkward to handle, and may result in injury to persons or
damage to property if not lifted properly.
WARNING!
Do not sit on or put your full weight on the
edge of the table. Serious injury could result.
CAUTION:
Proper screw length should allow ½” – ¾” of
threads to penetrate into the Top surface. Confirm proper
screw length before starting Top attachment. See Step 1.
Tools Required
5/16” Socket Driver or
Flathead Screwdriver
1/4” Hex Key (Allen Wrench)
Tape Measure
Permanent Marker (Felt Tip)
Safety Glasses
Parts List
(1) Spider Support
(1) Column: Dining Height or Bar
Height
(1) Base Plate
(1) Thumbscrew
(8) 5/16” x 1-1/4” Socket Head Cap
Screws
(8) #10 x 1-1/4” Self-Tapping Screws
Assembled tables are
large
&
heavy.
Put
together at place of use
.
Step 1
CAUTION: It is the assembler’s and user’s
responsibility to confirm and install proper
length screws to prevent damage to the Top.
Place one screw into the Spider Support mount.
Measure the length of the screw threads to
insure they stick up ½” – ¾”.
x
If the screw sticks up more than ¾”, do NOT proceed.
The screws are too long and will stick up through the
Top surface.
x
If the screw sticks up less than ½”, do NOT proceed.
The screws are too short and will not properly secure
the Top.
Step 2
Prepare a smooth, non-scratch work
surface (shipping container, a tarp or
pool towels can be used).
With two persons, place the Table
Top upside down on the prepared
work surface. Turn the Spider
Support upside down and place onto
the center of the Top.
Square tops
Be sure that the Spider
Support arms point toward the corners of
the top.
•
Top with umbrella hole
Sight down through the umbrella
support ring and align to the hole on the Top.
•
Top without umbrella hole
Measure equal distances from
the edge at four (4) places to center the Spider Support on the
Top.
Using the permanent marker, make a small, discrete mark on the
Base and the Top at two or more mounting points to indicate the
alignment.
Lift the Spider Support off the Top.
Do NOT attach the Spider
Support to the Top until Step 4.
SCREW LOCATIONS (8 PLACES)