Model: 03-5802-0000
Learjet Tailstand
11/2002 | Rev. 01
Page | 1
This product can not be modified without the written approval of Tronair, Inc. Any modifications done without written approval
voids all warranties and releases Tronair, Inc., it suppliers, distributors, employees, or financial institutions from any liability
from consequences that may occur. Only Tronair OEM replacement parts shall be used.
1.0
DESCRIPTION
This Tronair Tailstand incorporates the following quality features:
Steel construction
Easily maneuverable
Vertically adjustable to within
¼ inch
May be disassembled for easy replacement of parts or shipment.
2.0
USAGE
The purpose of this Tailstand is to support aircraft fuselage during maintenance.
3.0
ASSEMBLY INSTRUCTIONS
3.1
GENERAL INFORMATION
This product should be assembled and/or repaired using good workmanship practices and proper tools.
Bolts and elastic stopnuts should be tightened to a torque not to exceed industry standards for Grade '5' bolts.The 3/8-24 bolts
should be tightened to 35 ft-lbs and ½-20 bolts tightened to 85 ft-lbs.
All replacement parts must be the same as or equal to the original parts supplied.
3.2
PRE-USE CHECKS
Refer to the Illustrated Parts List to identify and ensure all components are present.
With extension collapsed, check over the unit to assure the tightness of all nuts, bolts and screws
3.3
ASSEMBLY STEPS
Slide extension inside base assembly. Adjust to desired height and insert lock pin.
4.0
PARTS LISTS
See following page for ordering information of Replacement Parts and Kits.
