Tronair 02-7802C0111, Operation & Service Manual

Page: 5 / 82

Model: 02-7802C0111 & 02A7802C0111 (with Air Pump)
12 Ton (10.88 Metric Ton) Single Stage Jack
04/2008 | Rev. 01 Page | 2
2.0 SAFETY INFORMATION (continued)
2.10 NECESSARY PERSONAL PROTECTIVE EQUIPMENT
CAUTION!
Always wear safety glasses.
2.11
SAFETY GUIDELINES
CAUTION!
Do not place hands on top of jack near ram locknuts while lowering jack. Pinch points exist between top of
jack and threads on ram.
1. NEVER put hands between the aircraft and the jack pad; as after aircraft has been lowered, struts
may have hung up.
2. NEVER align jack under aircraft by pounding on jack legs. Dented legs may lead to jack collapse.
3. ALWAYS lower ram locking nut(s) after jack is under load. Be sure ram nut(s) is seated fully after
jacking.
4. ALWAYS raise and lower jacks simultaneously so that aircraft remains level.
5. ALWAYS use a tail or nose stand, as applicable, for additional stability.
WARNING!
The ram locknuts are user operated safety devices. Failure to utilize these locknuts may result in personal
injury or death.
2.12
CONDITIONS FOR SAFE USE

Use in a clean dry environment on a level surface.

Operate between -20

C and 50

C (-4

F and 122

F).
2.13 OPERATOR QUALIFICATIONS
This jack is intended to be used by the skilled and trained aircraft technician. The operator must be familiar with the jacking
procedures for the aircraft to be raised, and the operation of the jack.
Installation/Maintenance/Dismantling Qualifications: This jack is to be installed, maintained, and dismantled by qualified
technicians familiar with hydraulic systems.
2.14
ADDITIONAL SAFETY MEASURES
This jack must be used in accordance with this technical manual, and in accordance with the aircraft manufacturer’s jacking
procedures.
3.0 PACKAGING AND STORAGE
3.1 PACKAGING REQUIREMENTS
Jacks are to be packaged as required to prevent damage to legs or hydraulic equipment during shipment.
3.2
HANDLING
Jacks can be rolled by hand on its casters.
3.3
STRAPPING
Jacks can be strapped down by suitable means to prevent unwanted movement during shipment.
3.4
PACKAGING PROTECTION
No special packaging material for cushioning or suspension is required.
3.5
LABELING OF PACKAGING
Packaging should be labeled DO NOT DROP .
3.6
STORAGE COMPATIBILITY
No special considerations.
3.7
STORAGE ENVIRONMENT

Store jacks between -20

C and +50

C/-4

F and 122

F.

Always store jack with ram all the way down.

Suitable for outdoor storage by using a full coverage waterproof tarp or canvas.
3.0 Packaging and storage continued on following page.