AIR XS USER MANUAL
15
8. HARDWARE INSTALLATION
Refer to section 4 of this user manual before undertaking the installation of the Air XS device. The
installation location of the Air XS device is the prerogative of the installer and care should be taken
to ensure an appropriate position has been selected. Consider the location of a suitable power
supply and external fuses, access to a communications network and the protection of cabling from
damage.
8.1 Safety precautions
1. Secure the Air XS to a suitable mounting surface using the integrated
mounting brackets.
2. Ensure that the Air XS is mounted in an upright position.
3. Unlock and open the enclosure door to access the internals of the
enclosure.
4. Ensure power is isolated before making electrical connections to the
instrument.
5. Power supply voltage and frequency must match the instrument (refer to
rating plate).
6. Ensure external switches or fuses are installed where applicable.
7. Run the required cables through the cable glands provided in the bottom of
the enclosure.
8. Wire the cables into the relevant terminals as indicated on the internal plate (refer to
9. Tighten the cable gland against the cable to ensure an IP seal.
10. Close and lock the door after use to maintain IP rating of the enclosure.
11. Ensure that the particulate entry and exit ports are not restricted or covered.
Note:
The instrument is susceptible to ingress when the door is
open
so care must be taken to ensure
the location is clean during installation.
