3
1. INSTALLATION
Connect one end of the coil cord to the handset and the other
end to the handset socket located on the left hand side of the
phone. Replace the handset to the cradle.
Connect the small plug of the telephone line cord to the
socket at the back of the unit and the other plug to the
telephone socket at the wall.
After connecting the telephone to the line socket, the
handset should be lifted to check dial tone is being received.
The DBT 1000 telephone is supplied with the mounting
bracket fixed in the wall mount position. For desk purposes,
you should remove the bracket and then replace in the
reverse position.
2. OPERATION
2.1 Follow On
During a call you can press the 'Follow On' button to
disconnect the call and obtain dial tone. This allows you to
set up a new call without having to replace the handset into
the phone base.
Installation & Operation
2
Operation
2.2 Redial Button
If you dial a number and find it is engaged or there is no reply,
replace the handset. The number will be retained in the
memory until you dial a different number.
What to do
:
Lift the handset
Press the REDIAL button
2.3 Ringer Pitch Setup
There are three options for the ringer pitch setting and they
are programmed as follows:
1. Lift the handset
2. Press '3'(Slow Ring), '6' (Normal Ring) or '9' (Fast Ring)
on the keypad
3. Replace the handset
2.4 Ringer Volume Setup
The ringer volume on the telephone can be set by the
switch located on the right hand side of the telephone.
Set the switch to either High, Low or OFF.
NOTE: When the ringer volume is set to OFF, the ringer
indication will still flash to show that the phone is ringing.
2.5 Receiver Volume Control
The receive volume can be adjusted UP or Down by pressing
the two volume control buttons. The phone will remember
the last volume setting when making a new call.
2.6 Mute Button
During a conversation the microphone on the telephone
handset can be muted by pressing the MUTE button. The
LED will flash to indicate that the mute is on. To turn off the
mute facility, press the mute button again.
MW1 SELECT
2 1 OFF
RINGER
OFF
LOW
HI
Message
Waiting
Ringer
Volume
