Trix 12333, Operating Instructions Manual

Page: 5 / 16

5
Safety Warnings
• This locomotive is to be used only with an operating
system designed for it.
• Use only power packs rated for your local household
power.
• This locomotive must never be supplied with power from
more than one power pack.
• Pay close attention to the safety warnings in the instruc -
tions for your operating system.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• WARNING! Sharp edges and points required for operation.
General Information
• The operating instructions are a component part of the
product and must therefore be kept in a safe place as
well as included with the product, if the latter is given to
someone else.
• Please see your authorized Märklin dealer for repairs or
spare parts.
• http://www.maerklin.com/en/imprint.html
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
that the non-Trix parts or the conversion were causal to the defects and /
or damage arising. The burden of presenting evidence and the burden of
proof thereof, that the installation of non-Trix parts or the conversion in or
of Trix products was not causal to the defects and / or damage arising, is
borne by the person and/or company responsible for the installation and /
or conversion, or by the customer.
Functions
• Trix locomotives can be operated on al 2-rail DC sys -
tems with conventional DC power packs (12 volt DC).
• An electronic overload protektion is build in to protect
the model.
• Triple headlights that change over with the direction of
travel.
• Close coupling between locomotive and tender.
• Analog 14 volts DC, digital 22 volts AC.
• Locomotive comes with NEM 651 digital
connector.
• Trix motor vehicles must not be operated on digital
systems without an in-built engine decoder (Motor can
be damaged!).
• Based on the NEM 661 standard, the speed of the loco -
motive at 12 volts is set approximately at the maximum
speed for the prototype.
NEM