General Information
81
Seats
Seat Care
To prevent damage to the seat or seat
cover, care must be taken not to drop or
lean the seat against any surface which
may damage the seat or seat cover.
See page 155 for seat cleaning
information.
Caution
To prevent damage to the seat or seat
cover, care must be taken not to drop
the seat. Do not lean the seat against
the motorcycle or any surface which
may damage the seat or seat cover.
Instead, place the seat, with the seat
cover facing upwards, on a clean, flat
surface which is covered with a soft
cloth.
Do not place any item on the seat
which may cause damage or staining
to the seat cover.
Passenger Seat
1
1.
Seat lock
The seat lock is located on the rear
fender, below the brake/tail light unit. To
remove the seat, insert the ignition key
into the seat lock and turn it
counterclockwise while pressing down
on the rear of the seat. This will release
the seat from its lock and allow it to be
slid rearwards. If equipped with heated
seats, disconnect the heated seat’s
electrical
connector
for
complete
removal from the motorcycle.
To reinstall the seat, reconnect the
heated seat’s electrical connector (if
equipped), engage the seat's two
brackets under the loops on the
subframe and press down at the rear to
engage in the seat lock.
1
2
2
cgif
1.
Passenger seat brackets
2.
Subframe loops
Warning
The rider's seat is only correctly
retained and supported once the
passenger seat is correctly installed.
Never ride the motorcycle with the
passenger seat detached or removed,
as the front seat will not be secure
and may move.
