Triumph Tiger 900 GT, Owner'S Handbook Manual

Page: 175 / 204

Cleaning and Storage
175
Where to be Careful
Caution
Do not use high pressure spray
washers or steam cleaners.
Use of high pressure spray washers
and steam cleaners may damage
seals, and cause water and steam
to be forced into bearings and other
components causing premature wear
from corrosion and loss of lubrication.
Caution
Do not spray any water at all near the
air intake duct.
The air intake duct is normally located
under the rider’s seat, under the fuel
tank or near the steering head.
Any water sprayed in this area could
enter the airbox and engine, causing
damage to both items.
Do not get water near the following
places:
• Air intake duct
• Any visible electrical components
• Brake cylinders and brake calipers
• Handlebar switch housings
• Headstock bearings
• Instruments
• Oil filler cap
• Rear bevel box breather (if fitted)
• Rear of headlights
• Seats
• Suspension seals and bearings
• Under the fuel tank
• Wheel bearings.
Note
Use of soaps that are highly alkaline will
leave a residue on painted surfaces, and
may also cause water spotting.
Always use a low alkaline soap to aid
the cleaning process.