Triumph Speed Triple 1200 RS, Owner'S Handbook Manual

Page: 69 / 184

General Information
69
Traction Control Settings
Warning
Do not attempt to adjust the traction
control settings while the motorcycle
is in motion as this may lead to loss of
motorcycle control and an accident.
Warning
If the traction control is disabled,
the motorcycle will handle as normal
but without traction control. In this
situation accelerating too hard on
wet/slippery road surfaces may cause
the rear wheel to slip, and may result
in loss of motorcycle control and an
accident.
The traction control can be set as
described on page 53.
If traction control is turned OFF, the TC
disabled warning light will be illuminated.
The traction control defaults to ON after
the ignition has been switched OFF and
then switched ON again.
Tyre Pressure Monitoring
System (TPMS) (if fitted)
Warning
The daily check of tyre pressures
must not be excluded because of
the fitment of the Tyre Pressure
Monitoring System (TPMS).
Check the tyre pressure when the
tyres are cold using an accurate tyre
pressure gauge, see the Tyre section
for more information.
Use of the TPMS system to set
inflation pressures may lead to
incorrect tyre pressures leading to
loss of motorcycle control and an
accident.
Note
The Tyre Pressure Monitoring System
(TPMS) is available as an accessory kit.
It must be fitted by your authorised
Triumph dealer.
The TPMS display on the instruments
will only be activated when the system
has been fitted.
Tyre pressure sensors are fitted to the
front and rear wheels. These sensors
measure the air pressure inside the
tyre and transmit pressure data to the
instruments. These sensors will not
transmit the data until the motorcycle
is travelling at a speed greater than
12 mph (20 km). Two dashes will be
shown in the display screen until
the tyre pressure signal is received.
The sensors in each wheel work
independent of each other. Therefore
the sensors can automatically switch on
and update at different times.