Triumph Scrambler 1200 Steve McQueen Edition, Owner'S Handbook Manual

Page: 38 / 196

General Information
38
Motorcycle Stationary - Engine Off
• The ignition is switched ON.
• The engine stop switch is in the
RUN position.
Motorcycle Stationary - Engine Running
• Neutral gear is selected.
Motorcycle in Motion
Within 30 seconds of selecting a riding
mode the rider must carry out the
following simultaneously:
• Close the throttle.
• Make sure that the brakes are not
engaged (allow the motorcycle to
coast).
Note
It is not possible to switch into or out of
Off-Road, Off-Road Pro or Rider modes
while the motorcycle is in motion, if the
ABS or TC settings are set to Off-road
or OFF in either of those modes.
In this case, the motorcycle must be
brought to a stop before the riding mode
change can take place.
If a riding mode change is not
completed, the icon will alternate
between the previous riding mode and
the newly selected riding mode until the
change is complete or it is canceled.
The riding mode selection is now
complete and normal riding can be
resumed.
Information Tray
Warning
When the motorcycle is in motion,
only attempt to switch between the
information tray modes or reset the
fuel information under the following
conditions:
- At low speed
- In traffic free areas
-
On straight and level roads or
surfaces
- In good road and weather conditions.
Failure to observe this important
warning could lead to loss of
motorcycle control and an accident.
The information tray appears at the
bottom of the display screen and allows
easy access to different motorcycle
status information.
To view the different information tray
items:
• Push the joystick left/right until the
required information tray item is
shown.
Note
To access the information tray, any
warning messages must first be
acknowledged, see page 39.