Triumph Scrambler 1200 Steve McQueen Edition, Owner'S Handbook Manual

Page: 137 / 196

Maintenance and Adjustment
137
• Detach the rear brake fluid reservoir
from the sprocket cover.
2
1
1. Sprocket cover
2. Rear brake fluid reservoir
• Loosen the rear brake fluid reservoir
cap retaining screws and remove
the reservoir cap noting the position
of the sealing diaphragm.
• Fill the reservoir to the UPPER level
line using new DOT 4 fluid from a
sealed container.
• Reinstall the reservoir cap making
sure that the diaphragm seal is
correctly positioned between the
reservoir cap and the reservoir
body.
• Tighten the reservoir cover
retaining screws to 9 lbf in (1 Nm).
• Reattach the rear brake fluid
reservoir to the sprocket cover.
• Reinstall the sprocket middle cover
and tighten the new fastener to
27 lbf in (3 Nm).
• Reinstall the sprocket outer cover
and tighten the fasteners to
80 lbf in (9 Nm).
Rear Brake Pedal Adjustment
Warning
The rear brake pedal may require
pressure to be applied to adjust it.
The rear brake pedal has sharp edges
that may cause injury to the hands
and fingers when applying pressure to
adjust it.
When adjusting the rear brake pedal
wear suitable gloves to avoid injury to
the hands and fingers.
Scrambler 1200 Steve McQueen Edition
and Scrambler 1200 XE Only
1
1. Rear brake pedal
The rear brake pedal is height
adjustable.
To adjust the rear brake pedal height:
• Lift the rear brake pedal up and
rotate it 180°. This will adjust the
height by +/- 0.39 in (10 mm).