146
Storage
Preparation after Storage
Install the battery (if removed) (see
page
129
).
If the motorcycle has been stored for more
than four months, change the engine oil (see
page
89
).
Check all the points listed in the Daily Safety
Checks section.
Before starting the engine, remove the spark
plugs from each cylinder.
Put the side stand down.
Crank the engine on the starter motor several
times until the oil pressure light goes out.
Re-install the spark plugs, tightening to
9 lbf-ft (12 Nm)
, and start the engine.
Check and if necessary correct the tire
pressures (see page
147
).
Clean the entire vehicle thoroughly.
Check the brakes for correct operation.
Test ride the motorcycle at low speeds.
