Triumph Bonneville Bobber, Owner'S Handbook Manual

Page: 116 / 142

Maintenance
116
Caution
Do not cover the headlight or lens with
any item likely to obstruct air flow to,
or prevent heat escaping from, the
headlight lens.
Covering the headlight lens during
operation with items of clothing,
luggage, adhesive tape, devices
intended to alter or adjust the
headlight beam or non genuine
headlight lens covers will cause the
headlight lens to overheat and distort,
causing irreparable damage to the
headlight assembly.
Damage caused by overheating is
not considered a manufacturing
defect and will not be covered under
warranty.
If the headlight must be covered
during use - such as taping of
the headlight lens required during
closed-course conditions - the
headlight must be disconnected.
Headlight Adjustment
cjwn
1
1. Headlight assembly mounting bolt
To adjust the headlight beam:
• Always make sure that the
handlebars are in the straight ahead
position.
• Vertical adjustment of the headlight
beam is controlled by loosening the
headlight assembly mounting bolts
and altering the position of the
headlight assembly.
• Retighten the headlight assembly
mounting bolt to 26 Nm.
Headlight Replacement
The headlight unit is a sealed,
maintenance free LED unit. The
headlight unit must be replaced in the
event of the failure of the rear lights.
Rear Light
The rear light units are sealed,
maintenance free LED units. The rear
light units must be replaced in the event
of the failure of the rear light.
Direction Indicator Lights
The direction indicator light units are
sealed, maintenance free LED units.