6
GB
Functions
POWER SWITCH
When the router is connected to
power, the Switch (3) will illuminate (in
both 'on' and 'off' positions).
The Retracting Switch Cover (4)
prevents accidental starting of the
router. It must be retracted before the
router can be switched on. The cover
will remain open until the router is
switched off.
ADJUSTING DEPTH OF CUT
There are three methods of cut depth adjustment, depending on
the accuracy and control required:
• Free Plunge, for conventional and fast depth adjustment
• Winder Handle Plunge, for controlled and fast adjustment
• Micro Adjuster, for precise depth setting throughout the full
plunge range
Free Plunge
1. Free plunge depth adjustments
can be made with the Plunge
Mode Selector Button (13)
engaged. Press it deep inside
the handle until it engages
inward
2. Release the Plunge Lock Lever
(10). Push the body of the router
until the desired depth is reached. Re-lock the plunge lock
lever
NOTE
: The position of the plunge lock lever can be altered by
removing its retaining screw and repositioning the lever on the
bolt. Re-tighten firmly.
Handle Winder Plunge
1. Check that the Plunge Mode
Selector Button (13) is not
engaged. If it is engaged, press
the button inward and allow it to
spring out flush with the handle
2. Ensure the Plunge Lock Lever
(10) is unlocked
3. Pull the Winder Handle Clutch Ring
(14) into the handle, then turn the
handle to raise or lower the cutter
4. Release the ring at the required
depth. It will ‘pop out’ and lock the
cutter at the set depth
5. Lock the Plunge Lock Lever (10),
particularly for heavy cuts
FUNCTIONS
Micro Adjuster
For use in Winder Handle Plunge Mode only
1. Disengage the Plunge Mode
Selector Button (13), and ensure
that the Plunge Lock Lever (10) is
unlocked
NOTE
: If the Micro Winder (12) is
turned with the plunge lock lever
engaged the micro winder will
start clicking and the cut depth will
remain unchanged.
2. Turn the Micro Winder (12) clockwise to increase cut depth
and anti-clockwise to reduce cut depth
NOTE
: When the end of the depth
adjustment range is reached the
micro winder will offer greater
resistance to turn and will begin
to ‘click’.
3. Lock the plunge lock lever,
particularly for heavy cuts
FITTING A ROUTER BIT
WARNING
: Always disconnect the tool
from the power supply before fitting
or removing a router bit.
1. Turn the power switch ‘off’,
allowing the retracting switch
shutter to close. (The retracting
shutter will lock closed when the
collet lock is engaged)
2. Place the router upside down, or on its side. With the motor
completely stopped plunge the router to its maximum depth
using the free plunge or winder handle plunge mode
NOTE
: Ensure the depth stop is fully retracted (see ‘Depth Stop
and Turret’). The collet should be
protruding through the base, allowing
easy spanner access.
3. Insert the Router Bit into the
collet then use the Spanner (21)
to turn the collet slightly, allowing
the collet lock to engage. Once
engaged, turn the spanner
clockwise to tighten the cutter
4. Return the router to a normal operating depth. This will
disengage the collet lock and release the retracting switch
shutter, allowing access to the power switch
330165_Z1MANPRO1(with Japanese).indd 6
21/07/2014 09:48
