Exe Inclusive Bar Mixer Shower
8
*VARIABLE FITTINGS
The supply pipes can be routed from the side,
rising, rear or falling and must end in suitable
fittings
(fig.8)
to accept the variable connectors.
The variable connectors can be used to connect
to ½” BSP female elbow fittings in solid wall
installations. The inlet centres on the variable
connectors have a degree of adjustment to allow
for misalignment of pipe work.
The hot and cold supply pipes
MUST
be
anchored rigidly to support the valve and stop
any movement after installation.
MAKING GOOD
Make good the wall and complete the tiling.
NOTE:
It is advised to use a suitable sealer
around the variable connector where it enters
the wall to stop water ingress
(fig.9)
.
Screw the supplied cover trims onto the fittings
until tight to the wall
(fig.9)
.
FITTING THE SHOWER
IMPORTANT:
Make sure that all supply
pipework has been flushed through before
fitting the mixer shower.
Offer the shower valve up to the fittings.
Check that the sealing washers are in place.
Screw the unions onto the fittings.
Fit the mixer controls
(figs.10 & 11)
and carry
out the commissioning procedure.
Fig.8
Appropriate
end fitting
Once the trim
is fitted, there
MUST
be a
minimum of
7mm
of thread
to allow the
mixer to be
fitted correctly.
7mm
Fig.9
Seal around
the variable
connectors
