- - XM572-V1.0-NR
7
[UP]
screen will flash when pressing this key in normal mode, the adress value will increasing. Keep pressing
this key, the address value will increase rapidly. it will exit from flash 60 seconds after the last keypress. Press
this key under edit mode, you can choose the function you want from the buttom up in the menu.
[DOWN]
screen will flash when pressing this key in normal mode, the adress value will idecreasing. Keep
pressing this key, the address value will decrease rapidly. it will exit from flash 60 seconds after the last
keypress. Press this key under edit mode, you can choose the function you want from the top down in the menu.
[ENTER]
this key is functionless when in normal mode. Press this key under the edit mode, it will enter into
next menu.
Default setting shaded.
Main Menu Functions
Main functions:
VALU
A001~A511 (AXXX)
DMX address setting
SLAV
ON/OFF (SLAV)
Slave setting
ADDR
EBOC
ON/OFF
Change DMX address via
external controller
ALON (AU-A)
Automatic Run in Stand Alone
AUTO
MAST (AU-M)
Automatic Run as Master
ALON (SO-A)
Sound-controlled Run in Stand
Alone
RUN
SOUN
MAST (SO-M)
Sound-controlled Run as Master
VALU
D–XX D-00 (DXXX)
Display the DMX 512 value of
each channel
RDIS
ON/OFF Reverse
display
CLDI
ON/OFF
Shut off LED display
0
MODE
DISP
LOCK
ON/OFF
Key Lock
RPAN
ON/OFF
Pan
Reverse
RTIL
ON/OFF
Tilt
Reverse
MIC
M-XX M-70
Mic sensitivity
AUTO
Clos/Hold/Auto/Audi
No DMX Status
FANS
HIGH/AUTO
Fan’s
mode
select
REST
Reset
LODA
ON/OFF
Restore factory settings
HIbE
OFF/1-99M 15M
Stand by mode
2
SET
VER V-1.0~V-9.9
Software
version
LADJ
ON/OFF
Lamp
adjustment
TEST
T–01~T–XX
Test function of each channel
CODE
CXXX
Fixture code *code is “C050”
3
ADJU
WHEL
CH01~CHXX XXXX(-128~127) Motor
Fix
MATI
0000~9999(hours)
Fixture running time
4
TIME
CLMT
ON/OFF
(Password is 838)
Clear fixture time
STEP
S–01 ~S–48
Steps of Program Run
REC.
RE.XX
Auto Save Scene
C–01~C–XX
XXX(000~255)
Edit the channels of each scene
TIME
XXXX(000.2s~199.8s)
Time for each scene
5
EDIT
SC01
~ SC48
CNIN
ON/OFF Edit
program
via
controller