Tritech Gemini 1200ik, Product Manual

Page: 16 / 31

0747-SOM-00004-01 Page 16 of 31
Assembly & Fitting of Monocle onto Mask (Using the OTS Accessory Rails)
The diagram above shows the parts required to assemble and mount the Monocle onto the OTS
Guardian diver mask
Item Qty Part No. Description
1 1 S12055 OTS Guardian Accessory Rail
2 1 S12363 Clamping Slide with 1/4" Hole
3 1 S12275 Shaped 1/4" Mounting Rod
4 1 S12467
DMD Monocle and Locking Assembly
To assemble and mount the sonar to the side of the mask:

Take the Clamping Slide [2] and slide onto the Accessory Rail [1]

Slide the long section of the 1/4
” bar [3] through the hole in the clamping slide [2], and when
the monocle is up against the diver mask turn the knob clockwise to lock the bar in place

Loosen \ unscrew the knurled section of the monocle mount assembly [4] and loosen \
unscrew 2.5mm hex screw [5]. The monocle can now be slid onto the angled rod and the
whole assembly mounted on the divers mask

The monocle slides onto the locking assembly as shown below: