TriStar ST-8142, User Manual

Page: 5 / 39

9
Operation and maintenance
UK
Remove all packaging of the device. Remove the plastic layer of the soleplate (no. 9).
Check if the voltage of the appliance corresponds to the main voltage of your home.
Rated voltage : AC220-240V 50Hz.
Filling your iron with water
Before filling water, please pull out the power cord out off the wall outlet and turn the
thermostat (No.1) to the MIN position. Fill the water tank (No. 8) with cold tap water to
maximum level, please be aware not to overfill.
Never add other liquids to the water!
The radius of the exhaust steam is very powerful, so make sure you do not focus on people,
pets or delicate points.
Use of your iron without steam
Turn the steam switch (No. 3) to the O position.
Set the thermostat switch (No. 1) on the iron to the desired position from MIN to MAX.
On the label in your garment you can find the correct thermostat position which is
appropiate for the garment. See the schedule for the meaning of the thermostat standings.
To remove stubborn wrinkles, you can press the spray button (No. 6) to bring your ironing to
moisten.
Use of your iron with steam
Turn the steam switch (No. 3) to position
for maximum steam or turn the steam switch (No. 3) to the right for less steam.
Set the thermostat switch (No. 1) on the iron to the desired position of MIN to MAX.
On the label in your garment, you can find the correct thermostat position which is appropiate
for the garment. See the schedule for the meaning of the thermostat standings.
Press the steam button (No. 7) to iron with steam.
To remove stubborn wrinkles, you can press the spray button (No. 6) to bring your ironing to
moisten. For an extra boost of steam press again the steambutton (No. 7).
GARMENT
LABEL
FABRIC
TYPE
THERMOSTAT
REGULATION
Synthetic
·Low
temperature
Silk - Wool
··Med
temperature
Cotton -
linen
··MAX
temperature
Fabric not to be ironed
10
To clean your iron
The following procedure is intended for daily use of the device, every 14 days to be conducted.
•
Fill the water tank (No. 8) with cold tap water.
•
Insert the plug into the wall outlet and set the thermostat (No. 1) to the MAX position.
•
Hold the iron above the sink.
•
Turn the steam switch (No.3) to position and press repeatedly the
steambutton (No. 7).
•
The steam holes in the soleplate (No. 9) are cleaned.
•
Turn the thermostat (No. 1) to the MIN-position and turn the steam switch (No. 7) to
the O position.
•
Dry the iron with a soft cloth. Note the soleplate (No. 9) is hot!
•
You should remove all the water before you store the iron.
Attention! The iron is very hot do not touch