4
1
2
3
A
4
5
4.2 Unpacking
Note:
If the enclosure is an “SP1” model with a shock pallet, follow the special unpacking instructions attached to the shipping container instead of the unpacking instructions in
this section. All warnings still apply.
1
Confirm that the shipping container is upright and stable, then use a utility blade to cut the
shrink-wrap securing the corner protectors. Apply the utility blade directly over the corner
protectors to prevent the utility blade from scratching the enclosure or cutting the heavy protective
plastic bag beneath the shrink-wrap.
WARNING: Do not scratch the enclosure or cut the heavy plastic bag beneath the shrink-
wrap. Do not push or pull the enclosure while unpacking.
2
Remove the corner protectors. Save all packing materials (including the pallet) for later use unless
you are certain they will not be required. The packing materials are recyclable.
3
Remove the heavy plastic bag surrounding the enclosure. Examine the enclosure for any damage
or loose parts. Confirm that all parts are present. If anything is missing or damaged, contact Tripp
Lite for assistance. Do not attempt to use the enclosure if it has been damaged.
4
Use the key to open the enclosure's doors and locate the 2 shipping brackets
A
that attach the
enclosure to the shipping pallet. The brackets are located inside the enclosure.
Note:
The keys are attached to the front of the enclosure.
5
Use a 13 mm open-end wrench to remove the shipping brackets. Be extremely careful, as the
enclosure could shift unexpectedly after bracket removal. Save the brackets and bracket hardware
for later use.
4. Enclosure Installation
