Tripp Lite NGI-S08C2POE8, Owner'S Manual

Page: 49 / 157

49
The control vlan of the instance must be same as the Control VLAN; otherwise, you will get an
error. If you still want to use this instance, you can change the Control VLAN to same as the
control vlan of the instance first. And then configures the instance.
4.5.1.1. ERPS Configuration
4.5.1.1.1. CLI Configuration
Node Command Description
enable show erps This command displays the ERPS configurations.
enable configure terminal This command changes the node to configure node.
configure erps enable This command enables the global ERPS on the
Switch.
configure no erps enable This command disables the global ERPS on the
Switch.
configure erps ring-id <1-255> This command creates an ERPS ring and its ID and
enter ERPS node.
configure no erps ring-id <1-255> This command creates an ERPS ring and enter
ERPS node to configure detail ring configurations.
erps-ring show This command displays the configurations of the
ring.
erps-ring control-vlan <1-4094> This command configures a control-vlan for the
ERPS ring.
erps-ring guard-timer <10-2000> This command configures the Guard Timer for the
ERPS ring. (default:500ms)
erps-ring holdoff-timer
<0-10000>
This command configures the Hold-off Timer for
the ERPS ring. (default:0 ms)
erps-ring left-port PORTID type
[owner|neighbor|norm
al]
This command configures the left port and type for
the ERPS ring.
erps-ring mel <0-7> This command configures a Control MEL for the
ERPS ring.
erps-ring name STRING This command configures a name for the ERPS
ring.
erps-ring revertive This command configures the revertive mode for
the ERPS ring.
erps-ring no revertive This command configures the non-revertive mode
for the ERPS ring.
erps-ring right-port PORTID type
[owner|neighbor|norm
al]
This command configures the right port and type
for the ERPS ring.
erps-ring ring enable This command enables the ring.
erps-ring no ring enable This command disables the ring.
erps-ring Version (v1|v2) This command configures a version for the ERPS
ring.
erps-ring wtr-timer <5-720> This command configures the WTR Timer for the
ERPS ring. (default: 300 seconds)