13
3.
Hardware Description
NGI-S08C2POE8 Front Panel
8 10/100/1000Base-T ports + 2 100FX/Gigabit SFP slots
Lite Managed Industrial PoE+ Ethernet Switch
3.1.
Connectors
The Switch utilizes ports with copper and SFP fiber port connectors functioning under
Ethernet/Fast Ethernet/Gigabit Ethernet standards.
10/100/1000Base-T Ports
The 10/100/1000Base-T ports support network speeds of 10Mbps, 100Mbps or 1000Mbps and
can operate in half- and full-duplex transfer modes. These ports also offer automatic
MDI/MDI-X crossover detection that gives true “plug-n-play” capability – just plug the
network cables into the ports and the ports will adjust according to the end-node devices. The
following are recommended cabling for the RJ45 connectors: (1) 10Mbps – Cat 3 or better; (2)
100/1000Mbps – Cat 5e or better.
SFP Slots for SFP Modules
The two SFP slots are designed to house 100FX/Gigabit SFP modules that support network
speed of 100FX/1000Mbps.
Installing the SFP modules and Fiber Cable
1.
Slide the selected SFP module into the selected SFP slot (Make sure the SFP module
is aligned correctly with the inside of the slot).
2.
Insert and slide the module into the SFP slot until it clicks into place.
3.
Remove any rubber plugs that may be present in the SFP module’s mouth.
4.
Align the fiber cable’s connector with the SFP module’s mouth and insert the
connector.
5.
Slide the connector in until a click is heard.
6.
If you want to pull the connector out, first push down the release clip on top of the
connector to release the connector from the SFP module.
Summary of Contents for NGI-S08C2POE8
Page 1: ......
Page 22: ...22...
Page 138: ...138 Action Click Delete to remove a configured trap receiver station...
