Tripp Lite NGI-M08C4-L2, Owner'S Manual

Page: 46 / 313

46
5.2.1. Static MAC
5.2.1.1. CLI Configuration
Node Command Description
enable show mac-address-table
(static|dynamic)
This command displays the current
static
/
dynamic
unicast address entries.
enable configure terminal This command changes the node to configure node.
configure mac-address-table static
MACADDR vlan <1-
4094> port PORT_ID
This command configures a static unicast entry.
configure no mac-address-table
static MACADDR vlan
<1-4094>
This command removes a static unicast entry from
the address table.
Example:
L2SWITCH(config)#mac-address-table static 00:11:22:33:44:55 vlan 1 port 1
5.2.1.2. Web Configuration
A static Media Access Control (MAC) address is an address that has been manually entered in
the MAC address table, and do not age out. When you set up static MAC address rules, you are
setting static MAC addresses for a port, so this may reduce the need for broadcasting.
Parameter Description
Static MAC Settings
MAC Address
Enter the MAC address of a computer or device that you want to add
to the MAC address table.
Valid format is hh:hh:hh:hh:hh:hh.
VLAN ID Enter the VLAN ID to apply to the computer or device.