214
Version
Select the version of the Simple Network Management Protocol
to use.
v1
or
v2c
.
Community String Specify the community string used with this remote trap
station.
Apply
Click
Apply
to take effect the settings.
Refresh
Click
Refresh
to begin configuring this screen afresh.
Trap Receiver List
No.
This field displays the index number of the trap receiver entry.
Click the number to modify the entry.
IP Version
This field displays the IP address version.
IP Address
This field displays the IP address of the remote trap station.
Version
This field displays the version of Simple Network Management
Protocol in use.
v1
or
v2c
.
Community String This field displays the community string used with this remote
trap station.
Action
Click
Delete
to remove a configured trap receiver station.
9.1.2.2.
Event Settings
The features allow users to enable/disables individual trap notification.
alarm-over-heat
- Trap when system’s temperature is too high.
alarm-over-load
- Trap when system is over load.
alarm-power-fail
- Trap when system power is over voltage/under voltage/
RPS over voltage/RPS under voltage.
bpdu
- Trap when port is blocked by BPDU Guard/BDPU Root
Guard/BPDU port state changed.
dual-homing
- Trap when port is blocked by Dual Homing.
dying-gasy
- Trap when system is power off.
loop-detection
- Trap when port is blocked by Loop Detection.
pd-alive
- Trap when PD device has no responses.
port-admin-state-change - Trap when port is enabled/disable by administrator.
port-link-change
- Trap when port is link up/down change.
power-source-change - Trap when the power source has been changed.
(AC to DC or DC to AC)
stp-topology-change
- Trap when the STP topology change.
traffic-monitor
- Trap when port is blocked by Traffic Monitor.
xpress-ring
- Trap when port is blocked by Xpress Ring.