144
6.10.2.
Web Configurations
Parameter
Description
Loop Detection Settings
State
Select this option to enable loop detection on the Switch.
MAC Address
Enter the destination MAC address the probe packets will be
sent to. If the port receives these same packets the port will be
shut down.
Port
Select a port on which to configure loop detection protection.
State
Select
Enable
to use the loop detection feature on the Switch.
Recovery State
Select
Enable
to reactivate the port automatically after the
designated recovery time has passed.
Recovery Time
Specify the recovery time in minutes that the Switch will wait
before reactivating the port. This can be between 1 to 60
minutes.
Apply
Click
Apply
to take effect the settings.
Refresh
Click
Refresh
to begin configuring this screen afresh.
Loop Detection Status