139
6.9.2.2.
Web Configurations
Parameter
Description
LACP Settings
State
Select
Enable
from the drop down box to enable Link
Aggregation Control Protocol (LACP).
Select
Disable
to not use LACP.
System Priority
LACP system priority is a number between 1 and 65,535. The
switch with the lowest system priority (and lowest port number if
system priority is the same) becomes the LACP “server”. The
LACP “server” controls the operation of LACP setup. Enter a
number to set the priority of an active port using Link Aggregation
Control Protocol (LACP). The smaller the number, the higher the
priority level.
Group LACP
Select a trunk group ID and then select whether to
Enable
or
Disable
Group Link Aggregation Control Protocol for that trunk
group.
Port Priority
Select a port or a range of ports to configure its (their) LACP
priority.
Apply
Click
Apply
to take effect the settings.