www.energyabsorption.com
Revision B December 2013
www.highwayguardrail.com
17
All rights in copyright reserved
13. Attach Electrical Sockets (PN 117404 and PN 117406) to rear of truck per detail drawing,
Sheet 1, provided in this booklet. Make sure that the electric cords on the Backup and
Cartridge can reach this location.
14. Position and re-attach TMA Support Frame (PN 615554) to the Support Frame Attachment
Brackets (PN 605399) using the 1” diameter pins provided. The Retainer Pins should be on
the inboard side of Support Frame.* Refer to Detail Drawings.
Note:
The cross member of the Upper Frame Support (PN 615578) may require removal at
this point (see Figure 2 on page 14). Torque 1” nuts until lock washers are fully compressed.
* Be sure Retainer Pins are correctly assembled:
Figure 6
(1) 13 mm [1/2”] THICK SHIM
(PN 614055)(TYPICAL)
BOLT, HX, 3/4 X 4”, G5
(Torque to 200 Nm
[150 ft-lb]
890 mm ±6 mm [33 3/4” ±1/4”]
(Inside dimension of outer tabs)
355 mm [14”] minimum
(Larger dimension preferred)
Move Lower Truck Brackets (PN 605505)
as low as possible (Minimum vertical
centerline to centerline is 355 mm [14”])
43 ±3 mm
[16 7/8” ±1/8”]
